Active
PT-SW-U324
2x4 USB 3.2 Gen1 Switcher with 5Gbps and Current Protection
The PT-SW-U324 is a USB 3.2 Gen1 switcher featuring two independently switchable USB-B host ports and four device ports—two USB-C and two USB-A—with support for data rates up to 5Gbps. Each device port provides …
ManualControl (TCP/IP)FAQSpecificationsDatasheetCEAvailable control interfaces. Expand an active type to see the full command table.
No matching commands.
API Commands15 commandsActive
Source: manual, chapter API Commands, page 14
| Command | Description | Example | Response | |
|---|---|---|---|---|
| ? | Get the list of all commands | ? | ||
| help | Get the list of all commands | help | ||
| get fw version | Get firmware version | get fw version | 1.0.0 | |
| set reboot | Reboot the device | set reboot | Reboot... System Initializing... Initialization Finished! FW: 1.0.0 | |
| set reset | Reset to factory defaults | set reset | Sure to RESET to default settings? Type "Yes" after next prompt to confirm... Input 1 | |
| get status | Get system status | get status | Please refer to the note at the end of the list. | |
| set key on/off | Set front panel key on/off Default: on | set key on set key off | Set key on. Set key off. | |
| get key | Get front panel key on/off status | get key | Key on. | |
| set input x | Set USB host input (x=1~2) x=1: USB host input 1 x=2: USB host input 2 Default: 1 | set input 1 | Set USB host input 1. | |
| get input | Get USB host input port | get input | 1 | |
| get usb5v | Get USB host input 5V | get usb5v | Host 1: 5V Host 2: none | |
| set autoswitch x | Set auto-switching on/off (USB 5V detection) x=On, Off Default: on | set autoswitch x | Set autoswitch on. | |
| get autoswitch | Get auto-switching status | get autoswitch | Autoswitch on. | |
| set output x usb5v y | Set USB device output (x=0~4) 5V to y x=[0...4]:0:All, 1:USB-C 1, 2:USB-C 2, 3:USB-A 3, 4:USB-A 4 y=0: Disable 5V output y=1: Follow host y=2: Force 5V always output Default: 1 | set output 0 usb5v 1 | Set all USB device output 5V:follow host. | |
| get output x usb5v | Get USB device output (x=0~4) 5V status | get output 0 usb5v | USB-C 1 5V: follow host USB-C 2 5V: follow host USB-A 3 5V: follow host USB-A 4 5V: follow host |